B. Functional Test|Customer Service Centre

Section B - Functional Test

Performing a functional test after the first time setup of an X35 is critical to ensure the Bourgault seeding system is operating as intended. Producers should also consider performing a functional test prior to the seeding season to verify operation and avoid costly down time during seeding.

Complete Documents
Entire Functional Test Document for 7000 Series with ASC - 147 pages (v4.02.511, Spring 2019)

Follow the steps below to perform a complete function test to verify the setup of the X35 prior to seeding.

B.1 - X35 Screen Overview

This clip shows a recommended screen setup prior to conducting the functional test on the air seeder system.

B.2 - Product Selection & Setup

Product type and rates are setup in the X35. Various rate examples are used to verify the auger and range selections for each tank.

B.3 - Load a Job

It is important to close any previous jobs and open a new job before each seeding operation.

B.4 - Fan Speed Test

Check that the fan or fans are capable of achieving the required speed for the desired seeding operation.

B.5 - Tank Calibration

The first functional test calibration video shows how to use the calibration wizard, and read the information provided.
The second calibration video shows how to check that the metering system on each tank will achieve the rates required for the given products. A max fan speed check is also demonstrated.

			Part 1
			Part 2

B.6 - NH3 / Liquid Test

NH3/Liquid Test using 3151-47 harness - These instructions are written for the X30 Controller, but apply to the X35 testing procedure as well. You will require test harnes 3151-47.

with 3151-47 harness

without 3151-47 harness

Return to CSC Index