Service
Monitors & Controllers
X35
6000 Series Cart
Apollo Maintenance and Troubleshooting
Guides to help diagnose and repair problems with Apollo monitoring system for X30 and X35 monitors.
PDF drawings tracing the different flow through the Apollo wiring. These can be used with the videos on this page as well.
Apollo Can Hi and Low troubleshooting - Drawings following the Can Hi-Low signals from the monitor through the different ECU's - PDF
Full HC power through ECU's - Drawings following the High Current power flow from the batteries to the ECU's - PDF
Safety switch complete - Drawings following the flow of the safety switch wiring - PDF
The following videos will walk you through diagnosing problems with the Apollo system
1. Leading Can Hi-Lo Drawings - Apollo Troubleshooting
This presentation instructs you how to follow through the Can Hi-Lo on wiring schematics from Apollo Monitor to end of signal for Leading (Tow Between) air seeders.
2. Trailing Can Hi-Lo Drawings - Apollo Troubleshooting
This presentation instructs you how to follow through the Can Hi-Lo on wiring schematics from Apollo Monitor to end of signal for Trailing (Tow Behind) air seeders.
3. Can Hi-Lo Pin Out's & Locations - Apollo Troubleshooting
Follow through with harnesses layed out and explain the pins and locations of the pins to be checked
4. High Current Power Supply - Apollo Troubleshooting
Use for diagnosing and repair of power issues with the Apollo system
5. High Current Power Supply Harnesses
Follows through with harnesses laid out and explain the pins and locations of the pins to be checked.
6. Red Error Messages - Apollo Troubleshooting
How to use the Red Error code messages to simplify troubleshooting.
Safety Switch Wiring, X35 Controller
The safety switch allows the X35 to communicate with the ECUs while allowing the implement to be worked on without the X35 able to control the functions of the unit.